dust test chamber is suitable for detecting a shell seal of the product Performance, mainly used for two levels of IP5X and IP6X specified in the housing protection level. It is mainly to simulate the destruction caused by sandstorm weather on locks, automobile and motorcycle parts, seals, power meters and other products.
dust test chamber
dust test chamber During the test, It may cause the dust test chamber to run malfunctions due to power outages, operational failures, etc., how to deal with test failures without affecting the reliability of test results, and true nature. Wuhan Test Equipment Co., Ltd. summarizes several points on dust test chambers in troubleshooting methods.
First, the dust test box turning meter is not bright: check whether the power supply is normal, check whether the preface Normal,
has a zero line.
Second, no blow: Check if the blower is working properly or the fan is too small, check whether the dust is dry.
Third, no vibration: Check if the vibration motor is normal.
4, dust test chamber should have a special person management operation, and regularly cleaning the cabinet and blower, periodically Professionals should be maintained.
5, in order to stably play the test chamberFunction, performance, should be selected between fifteen to twenty-five degrees, relative humidity is less than 85%.
6, the distance between adjacent walls or utensils.The ambient temperature of the installation site should be drastically changed. It should be installed in a place where direct sunlight should be installed. It should be installed in a well-ventilated place, away from flammable and high temperature heat source, and the equipment should be installed in a small place where dust is installed, and install as much as possiblePlaces near the power supply.
Seven, the device is dead: check whether the power supply is normal, check whether the phase sequence is normal, whether there is a zero line.