النشرة الإخبارية Rain simulation test chamber

Rain simulation test chamber is mainly used to test the performance of the product during storage, transportation and use in a rainy climate environment, and is mainly suitable for Outdoor lighting, outdoor lamps, automotive lamps, home appliances, electrical appliances, communications products, signaling equipment and other products are used to test the casing protection level (IP waterproof test), which is specially used to test equipment waterproof level is an ideal testing institute testing equipment and equivalent other effective water testing methods .

The rain test chamber meets the standard

GB 2423.23-1995 Degree of protection of sealed enclosures for environmental testing of electronic and electrical products

GB5170.20- 1990Rain test

IPX3 water test (a pendulum-type rain test b nozzle-type rain test)

IPX4 splash water test (pendulum splash water test b nozzle splash water test)

IPX5 splash water test

IPX6 strong water spray test

The most important performance parameters of the rain simulation test chamber

IPX3 IPX4

swing tube swing

±60°, ±90°、±180°（theoretical value）

hole spacing

50mm

Nozzle

φ0.4mm

Rainwater Pressure

80-100kpa

test bench diameter

800mm

test bench speed

1r/min (can be continuously adjusted (optional))

Controller

frequency modulation inverter

Water pressure control

Flow meter

Water supply system

Water Storage, Boost Pump

IPX5 IPX6

IPX5: water spray test, the spray nozzle diameter is 6.3mm, the distance between the test sample and the water spray hole is 2.5-3m und the water flow rate is 12.5 l/min (750 l/h). Test time: calculated according to the surface of the sample shell tested, 1 minute per square meter (excluding installation area) less than 3 minutes.

IPX6: Intensive water spray test, the nozzle diameter is 12.5mm, the distance between the test sample and the water spray hole is 2.5-3m, and the water flow rate is 100L/min (6000L/h). Test time: calculated according to the surface of the shell of the sample tested, 1 minute per square meter (excluding the installation area) and 3 minutes less.