النشرة Resources IPX Rainproof Test Chamber

IPX Rainproof Test Chamber In the standard, the IP waterproof level is divided into detailed levels, and the rain test is also called the waterproof test.

The IPX5, IPX6 rain test chamber and waterproof test chamber are because they have the same thing and Tired and similar conditions so that they can complete the two levels of experimentation in the same hardware setup. Let me talk about the similarities and differences of their class requirements:

First, they all require a water spray test, and the different IPX6 requirement is a strong water spray test.

Secondly, adjust the distance between the test sample and the water nozzle to 2.5-3m, while IPX5 water flow 12.5L/min (750L/h) and IPX6 water flow 100L/min (6000L /h) required.

Third: The inner diameter of the nozzle of the IPX5 nozzle must6.3mm, while the inner diameter of the nozzle of the IPX6 nozzle must be 12.5mm. From the above characteristics, it can be seen that they have the same height, to make the distance between the test sample and the water nozzle 2.5-3m, only the water flow rate and the inner diameter of the water nozzle need to be different, then we install two nozzles on same chamber water head including 1 IP5 nozzle and 1 IP6 nozzle.

The rain test chamber and waterproof test room are each composed of a product test placement table, a control box, a water storage tank, a slope, a buffer zone for sample drainage, and a spray system, etc. composition.

The material is as follows:

1. Nozzle: galvanized pipe.

2. Water tank: SUS304 stainless steel plate.

3. Worktop: non-slip aluminumreplate.

4. Support inside the table: square pass in stainless steel.

IPX Rainproof Test ChamberParameters:

1. Test the total size of the table: approx. 1500 deep x 2000 wide x high approx. 3500㎜ (non-standard customization is available).