النشرة الإخبارية Tianjin high and low temperature constant temperature test chamber

Tianjin high and low temperature constant temperature test chamberIt is often used in batteries, electrical appliances , electrical and electronic equipment, optoelectronics, communications, computer accessories, mobile phone accessories or complete machines, telephones, refrigerator accessories and other industrial products applicable to all industries. Finished or semi-finished proproducts, accessories or complete parts . The structure of this test equipment is: integral type, the upper end is the product placement test room, the lower end is the cooling system and humidification system, the right end is the control system, and the control panel is located on the front right side of the test box. The rear end of the test chamber is the air duct circulation system including: heater, air supply motor, centrifugal fan blade, heat exchanger and other components.

Default inner box size is optional:

Corresponding to a volume of 30 liters: width 25x height 40x depth 30cm;

volume 50 liters corresponds to: width 35x height 40x 35cm deep;

corresponds to a volume of 80 liters of: width 40x height 50x depth 40cm;

Default temperature range selectable:

A: 0℃ ~ 150℃;

B:-20℃~150℃;

C:-40℃~150℃;

D:-60℃~ 150℃;

F: -70℃~150℃;

Tianjin high and low temperature constant temperatureur test chamberTechnical parameters

2. Temperature fluctuation: ±0.5℃ (no load)

3. Temperature uniformity: ≤±2℃ (no load)

5 、 coolerate: 0.7~1.2℃/min

6. Heating rate: 1.0~3.0℃/min

7. Time setting range: One segment is 999 hours and 59 minutes, one program is 120 segments, and there are 120 programs that can be run 9999 times.

8, noise: ＜65dB

Corresponds to the standard

GB /T10589-2008 Cryogenic Test Chamber Technical Specifications

·GB/T10592-2008 Technical conditions for high and low temperature test chamber

GB2423.1-2008 Low Temperature Test Aa , Ab

MIL-STD810D Method 502.2

GB/T2423.4-2008 (MIL-STD810) Method 507.2 Program 3

Default configuration:

A. 5 pieces of non-woven fabric for standard test

B. Power cord 4.0 mm x 4 conductors, low impedance rubber cable, 2.5 m long, 1 piece

C. An RS-232C communication interface terminal (9PIN)

D. 2 sets of stainless steel shelf rails with adjustable spacing of 40mm

E . SUS #304 stainless steel square perforated steel shelf 2 pieces

F. An 11W energy-saving window light

G. A ψ50mm test hole on the left side of the body with a stainless steel hole cover, 1 silicone plug.

H. A set of fuses (consumables)

I. One set of controller manuals, one set of manuals, one test report