Electromagnetic vibration pull-in test bench is suitable for detecting early failures, especially detecting faulty welds on electronic products, simulating actual working condition evaluation, and structural strength testing.
Electronic vibration table is also called electronic vibration test bench, which is widely used in aviation, national defense, aerospace, electronics, communications, automobile and motorcycle, home appliances and other industries. This type of vibrating table is suitable for early detection of defects, especially for detecting faulty welds on electronic products, simulating actual working condition evaluation, and structural strength testing. QINSUN series vibrating tables have a breites range of applications and a wide range of applications with obvious and reliable test results.
Electromagnetic suction test bench Frequency
1, 50Hz/working frequency/ Power frequency
2.1～99.9 Hz] can be set arbitrarily (±0.1℃%) (B series)
3, 0.5～600 Hz] can be any setting (±0.1℃%)
4, 0.5～3000 Hz] can be set arbitrarily (±0.1℃%)
5, 0.5～(5000/10000) Hz] can be set arbitrarily (±0.1℃%) Sweep function: (high frequency/low frequency range) can be set arbitrarily True standard logarithmic frequency sweep function back and forth: ①down to top frequency ②up to bottom frequency ③down to top and bottom frequency- - 3 modes logarithmic/repeatable
Maximum load: 100kg to 1000kg or more can be customized by QINSUN. Vibration waveform: sine wave (full wave/half wave) Precision: frequency can be displayed up to 0.01Hz, Control accuracy 0.1Hz Maximum acceleration: 0-15G Supply voltage (V): 220 ± 10%
Main technical parameters:
(1) Vibration table size: 500 x 500 mm (one body);
(2) Vibration direction: vertical + horizontal
(3) Maximum load: 50KG;(4) Frequency range: 1-200 Hz;
(5) FM range: Freely adjust within the frequency range of 1-200 Hz;
(6) Frequency sweep range: 1-200 Hz (After setting the upper cutoff frequency, the lower cutoff frequency and the time range, the device sweeps back and forth within the set frequency range : for example set the upper limit frequency to 60 Hz, the lower limit frequency to 10 Hz, set the time auf 1 minute, the machine sweeps back and forth between 10-60 Hz and then 60-10 Hz);
(7) amplitude (no load ) : 0–5 mm; (The amplitude at each frequency is different and the amplitude can be adjusted. Within the frequency sweep range, the amplitude changes with frequency)
You can Send Message or email email@example.com to us, we will reply tu you within 24 hours.Now tell us your need,there will be more favorable prices!
No. 2578 Gu Dai Road, Shanghai