النشرة الإخبارية Experimental dustproof and waterproof equipment

Experimental dustproof and waterproof equipment is mainly used to test the dust and sand resistance of industrial products, which can simulate flying specimens in the sand. fine stones and dust The actual performance comparison test of the samples in the normal environment and the normal environment.

Experimental dustproof and waterproof equipment meets the following standards:

IEC 529-1989 Chinese term: enclosure protection class (protection class code).

GB4208-2008 enclosure protection level (IP code) national standard.

GB/T 2423.37-2006 | Environmental testing of electrical and electronic products - Part 2: Test L sand test method.

GJB150.12 Environmental Testing Methods for Equipment, Part 12: Sand Dust Test.

GB/T10485-2007 Road vehicles - Exterior lighting and light signaling equipment - Environmental resistance and other equivalent sand and dust resistance test standards.

The current model of the IP56 dust test chamber

Studio dimensions (D×W×H, mm)

LQ-IP-500

800×800×800

LQ-IP-800

800×1000×1000

LQ-IP-1000

1000 ×1000×1000

LQ-IP-1500

1000×1500 ×1000

Safety guard:

1. The dust box is equipped with an ultra-high temperature Sprotection device to prevent the temperature control from affecting the test and causing caution.

2. The default setting is a single box 220V power supply. If a three-phase power supply is installed, it has underphase and phase sequence protection for three-phase voltage to prevent the fan from reverse operation.

3. A time accumulator is installed to prevent accidental interruption of the test, and the time limit for exposure to sand and dust can be known at any time without knowing the time of the point of interruption.

Sand dust control system:

1. QINSUN chooses the Korean original touchable program for the controller.

2. Parameter setting is simple, no need to enter the program menu, Sie can enter the parameter menu directly to

3. It can control the total time of the test, the intermittent time of dust blowing, and the cycle of dust blowing.

4. The temperature adopts the RKCDC temperature controller, which can be adjusted to RT + 5 ~ 60 ° C to prevent the test dust in the box from being affected by the humidity in the air.

5. The test tank and control cabinet are integrated, with casters in the lower part, and other systems are hidden, beautiful and generous.