We Have More Than 10 Years of Experience.
   
   
top-ban
  1. HOME > Blog

Uv Lamp Tester cost in Poland

    2022-12-15

    UV lamp tester | Support for Miltec UV

    . Phone: +1 410-604-2900 Email: service-miltec . Technical Support After Hours (5:00 PM - 8:00 AM EST) (GMT -5): +1 443-591-2326

    Amtast UVA365 UV Photometer Light Tester UVA

    * UV Sensor Spectrum: Bandwidth 320nm~390nm * Accuracy: ±(4%FS+2dgt) Calibration under standard UVA light and comparison; Specifically tested under environmental conditions RF field strength less than 3 V/M and frequency less than 30 MHz only * Sensor structure: Proprietary UV photodiode and UV color correction filter. *Sampling time: 2.5 times/s.

    SPDIUV LT1 Electronic UV Lamp Tester Please note that some types of so-called quick-start lamps cannot be tested. This device is designed to test medium and low pressure gas filled lamps. The following lampsantes can be tested:

    UV lamp tester price.

    UniVerselle T-229/4P UV/IR flame detector test lamp

    The T-229/4The universal test lamp for UV/IR flame detector P activates UV, IR and UV/IR flame detectors operating at 185-235 nm UV and wideband IR. For use in safe areas only. Ask SENSE-WARE if your flame detector can be tested with the T-229/4P. Almost all UV, IR and UV/IR flame detectors can be tested with the T-229/4P using the

    SPDIUV LT1 Electronic UV Lamp Testing Device. Please note that some types of so-called quick-start lamps cannot be tested. This device is designed to test medium and low pressure gas filled lamps. The following lamps can be tested:

    UV lamp tester price.

    Manufacturers and suppliersUV lamp tester rs

    UV lamp tester manufacturer in China

    TEKIZOO UVB tester, UV sensor, quick test card UVB

    This item: TEKIZOO UVB Tester UV Sensor UVB Reptile Quick Test Card UV Lamp Fluorescent UV Bulb Solar Lamp (2 pcs) $6.89 ($3.45/piece) TEKIZOO UVA-UVB - Solar High Intensity Heat Aaling Lamp/Light/Bulb with Ballast for Reptiles and Amphibians (125W) =swt>Universal T-229/4P UV/IR Flame Detector Test Lamp

    The T-229/4P Flame Detector Test Kit activates UV, IR and UV/IR flame detectors operating at 185-235 nm UV and broadband IR radiation. For use in safe areas only. Ask SENSE-WARE if your flame detector can be tested with the T-229/4P.

    Application and Usage of Multi-Probe UV Light Tester - Linshang Tech

    LS125+U Multi-Probe UV Light TesterVALED-X0 Main application: Spectral Response is 340-420 nm, used for LED light source detection hardening Power measurement range: 0-20,000 mW/cm² Test aperture: 10 mm Optional units: mW /cm², W/cm², W/m² Model: LS125 + UVALED-X0Contact us See details Multi-probe UV light tester LS125 + UVALED-X1

    UV lamp tester price.

    UV tester price

    UV and photochromic lens tester Model UV-888 FOB price: 100-3000 US$ / piece Min. Order: 1 piece New Vision Meditec Co., Limited Enlarge video and image Order: 1 piece Guangdong New Vision Film Technology Co., Limited

    TEKIZOO UVB Tester UV Sensor UVB Quick Test Card

    This item: TEKIZOO UVB Tester UV Sensor UVB Quick Test Card for Fluorescent UVB Lamp Solar UVB Lamp (2pcs 125W) swt>UV Intensity Tester | Germicidal Lamp - Linshang Tech

    It is best to use the LS126C UV intensity tester. The germicidal lamp used must be renewed every six months. The UV germicidal lamp should be replaced when the lamp intensity is less than 70 W/cm2. For the intensity of the new lamp, the normal 30W straight tube germicidal lamp should not be less than 90W/cm2.

    UVC luxmeters, systems and detectors disinfectionctors

    UVC lumometers to measure UVC from mercury lamps, UV LEDs and light sources with excimer - 230 - 280 nanometers. The ILT2400-UVC is a complete system for measuring UVC output from broadband and narrowband germicidal/disinfectant light sources such as mercury lamps and LEDs. Check immediately if the UVC value is sufficient to disinfect the surface.

    Portable UV Light - UV Inspection Lamp - Spectroline UV Lamp

    All relevant CND codes definedbetween these values. It should be noted that older mercury vapor lamps lose intensity with age, use and pollution. As a result, the intensity decreases over time. We offer radiometers (UV meters) and photometers (visible light meters) from Spectronics, Baugh & Weedon, Gould-Bass, UV Products, Magnaflux

    Price per UV lamp tester<

    Please contact suppliers directly and discuss UV lamp tester price specifications / other requirements e.g. B. method of payment. With them via our online messaging sursystem

    UV Intensity Tester | Germicidal Lamp - Linshang Tech

    It is best to use LS126C UV Intensity Tester. The germicidal lamp used should be checked every six months. The UV germicidal lamp must be replaced when the lamp intensity is less than 70 W/cm2. For the intensity of the new lamp, the la30W normal straight tube germicidal mpe should not be less than 90W/cm2.

    QuantaDose® UVC Light Test Card with UVC Light Wavelength

    This item: QuantaDose® UVC Light Test Card with UVC Light Wavelength Indicator and UV Photochromic Intensity Test $9.63 Professional UV Light Protective Glasses - One Size Fits All Unbreakable UVC safety glasses made of polycarbonate to block up to 400 UV rays and light Blue - ANSI Z87.1 Approved with Amber Tinted Lenses $16.95 ($16.95/each)

    Portable UV Lamp - UV Inspection Lamp - Lamp UV Spectroline

    All relevant CND codes prescribe these values. It should be noted that o Older mercury vapor lamps lose intensity with age, use and pollution. As a result, the intensity decreases over time. We offer radiometers (UV meters) and photmeters (visible light meters) from Spectronics, Baugh & Weedon, Gould-Bass, UV Products, Magnaflux

    Universal UV/IR T-Test Lamp Flamingtektor -229 /4P

    The T-229/4P Flame Detector Test Kit activates UV, IR and UV/IR flame detectors operating at 185-235 nm broadband UV and IR radiation. For use in safe areas only. Ask SENSE-WARE if your flame detector can be tested with the T-229/4P.

    FT194 Portable UV/IR Flame Detector Test Lights - Safety System

    The FT194 test light activates flame detection systems Safety Technology's triple mode UV/IR optical flame at a distance of up to 1.5 meters from the detector. To operate the test lamp, press the test lamp switch and point it directly at the detector under test.

What Can I Do For You?

You can Send Message or email info@qinsun-lab.com to us, we will reply tu you within 24 hours.Now tell us your need,there will be more favorable prices!

toTop