High and low temperature test box relocation should pay attention to refrigeration system

Refrigeration system maintenance small common sense

1 [ It is recommended to place it in temperature

8 ° C ~ 28 ° C , there is no laboratory without this condition , Equipped with appropriate air conditioners Thermal performance, water-cooled, must guarantee the water pressure and water temperature and the corresponding flow
3 , periodically cleans the evaporator, because the cleansing level of the test material is different, in force The evaporator will condense a lot of dust small particulate objects under the circulator

Due to laboratory expansion or other requirements,

high and low temperature test chamber

may involve

ldquo Moving rdquo , and it is necessary to pay attention to ZUI in the relocation process. The refrigeration system is refrigerating system. The refrigeration system is the core of the high and low temperature test chamber Heart part, during handling Tilt, collisions, etc. will cause refrigerant to leak, so that the low temperature of the test chamber can not fall or cool down. Handling is a measure of major safety hazards. If there is less than 10,000 cases recommend not adopting artificial handling, in order to meet technical parameters, you need to focus on forklift, elevator, aisle, corridor Whether the places such as doors need to meet the test chamber smooth pass, and arrive at the location, Beijing QINSUNring test high low temperature series test box bottom installation high quality can be fixed PU Active wheel, can be Easily move the machine to the position, ZUI fix the cassette, if the device is placed directly on the first floor, use the manual hydraulic forklift to remove the laboratory, if the test chamber is placed upstairs, should pay attention to whether there is The elevator, the width of the elevator and the aisle, corridor, and the door need to pass through the test chamber, and if there is no elevator to handle it, be careful. If there is a high-low temperature test chamber due to site, it must pay attention to whether the stairway can accommodate the equipment and turn of the equipment. If the test chamber is manually handled, you can't run the machine immediately after reaching the location should be placed 2 to
3 days, and then check whether the device has problems.